Page MenuHomeAleph Objects Inc

Not heating at all for prints
Open, HighPublic

Description

I was testing firmware version 2.0.0.170 per T8628.

I tried to start a print and the printer was not heating up at all. The temps for both nozzles stayed around 30C. Despite the printer briefly saying it was heating up, both nozzles would display 30/0. It never fails out and continues to go through all the motions of a regular print.

I let it run for a while, and the temps never changed. The extruder motors never turned either, so there was no stripping out. (I'm assuming they don't turn when the nozzles are below a certain temp.)

Related Objects

Event Timeline

matth created this task.Oct 11 2019, 11:57 AM
matth triaged this task as High priority.
tutley added a subscriber: tutley.Oct 11 2019, 12:00 PM

can you try .173 or later?

I tried 173 and got the same result.

I downgraded back to 149 and it works as intended. Has the target temps and is heating like normal.