Page MenuHomeAleph Objects Inc

Cura LE stop on nozzle wipe during autolevel - Mini
Closed, InvalidPublic

Description

Description of the issue: I could not use the new cura without flashing the new firmware but after upgrading my lulzbot mini firmware to 1.15.44 , my lulzbot failed to perform the initial calibration , it tries to calibrate and goes back to wipe the nozzle and stops automatically.

Event Timeline

alexei assigned this task to marcio.Dec 8 2017, 7:08 AM
alexei triaged this task as High priority.
alexei added a project: Marlin.
alexei added subscribers: marcio, alexei.
alexei moved this task from Restricted Project Column to Restricted Project Column on the Restricted Project board.Dec 8 2017, 8:04 AM
TyTh added a subscriber: TyTh.Dec 8 2017, 8:59 AM

Can't reproduce on the Mini in TSR. Used the firmware listed but on Cura 2.6.58

Closing this task

nickp closed this task as Invalid.Dec 8 2017, 9:01 AM
alexei changed the edit policy from "Custom Policy" to "Restricted Project (Project)".Dec 11 2017, 4:03 PM