Page MenuHomeAleph Objects Inc

Add M73 P0 to all start gcodes
Closed, ResolvedPublic

Description

The progress on the lcd doesnt update properly. If you start a print let it run a bit, cancel then start the print again, the progress bar stays at the percentage when you stopped the print throughout the start g code

Event Timeline

west created this task.Nov 21 2018, 7:55 AM

@west Are you canceling via GLCD or Cura? I suspect we can add in a command to clear the progress bar when canceling, or adding something to start gcode to set progress bar to 0 when starting a print.

karrad changed the edit policy from "All Users" to "Cura LulzBot Edition (Project)".Nov 21 2018, 11:48 AM
karrad triaged this task as Normal priority.
karrad moved this task from Backlog to Next Release (3.6) on the Cura LulzBot Edition board.
karrad removed karrad as the assignee of this task.
karrad added a subscriber: karrad.

@west Can you add an M73 P0 to the beginning of your start gcode and try to duplicate? This should reset the progress bar to 0 at the start of a new print.

karrad claimed this task.Dec 7 2018, 12:22 PM
karrad renamed this task from 3.2.32 mini 2 lcd status dot updating to 3.2.32 lcd status not updating.Dec 7 2018, 2:44 PM
west added a comment.Dec 10 2018, 7:24 AM

@karrad adding that worked

@west Thanks for checking. Just to verify, the LCD would then update progress as usual?

karrad renamed this task from 3.2.32 lcd status not updating to Add M73 P0 to all start gcodes.Dec 10 2018, 7:48 AM

After testing a couple aborts/restarts progress is reset and updates normally on restarts

karrad closed this task as Resolved.Dec 10 2018, 9:18 AM

Added M73 P0 to all start gcodes, updated tool head names