Page MenuHomeAleph Objects Inc

bridge gap on flexy corner
Closed, ResolvedPublic

Description

to reduce retraction and stringing, we can bridge the 2 posts that help retain the bed

Event Timeline

west created this task.Nov 21 2018, 9:12 AM

@kent @Steven this is ready to be approved

Steven reassigned this task from west to kent.Nov 21 2018, 12:25 PM

These look good to me

kent added a comment.Jan 9 2019, 9:42 AM

These are installed on quiver 18 and quiver 6 now.

We need to get these on a couple more machines and make sure they don't bow the glass and then we can merge them in.

kent reopened this task as Open.Jan 9 2019, 9:43 AM
kent moved this task from Alpha Sprint (2019/01/04) to Needs Review on the Quiver board.

opening this up again since the changes to the part are on the branch with this ticket number as a name.

west added a comment.Jan 9 2019, 9:51 AM

@kent There is a slice request for 16 to test out on 4 machines. I think it would be best to use 2 sets on machines that are exhibiting a lot of bow on the glass and 2 sets on a sagging heat bed (if we have any right now)

logan added a comment.Jan 9 2019, 9:57 AM

The latest "soft" corners are installed on Q11 and alleviated the extreme bow I was seeing, for the record.

Ok this has been installed and tested so I merged it in. It sounds like the slicer settings are very important to this part working as intended. I noticed there was a cura profile included with the slice request ticket so that should give a good starting point for @EricNugent to make a production slice with. @EricNugent if there is anything that needs changed in that profile to pass strenth and fit tests, list it in the ticket please.

kent closed this task as Resolved.Jan 9 2019, 10:17 AM