Page MenuHomeAleph Objects Inc

Add "1" and "2" to corresponding filament sensor covers to reduce confusion
Closed, DuplicatePublic


We should consider adding markings to the filament sensor covers to identify which side to pluf in e1 or e2 sensor

Event Timeline

west created this task.Nov 27 2018, 11:10 AM
west added a comment.Nov 27 2018, 11:19 AM

This could also change the naming of the covers from cover L and cover R to cover 1 and cover 2 which would need to change in the BoM and odoo

west added a comment.Nov 27 2018, 11:22 AM

In addition with labeling the tubes

@Steven @kent ready for review at least for the printed parts

west reassigned this task from west to kent.Nov 27 2018, 1:43 PM
Steven added a comment.Jan 8 2019, 2:38 PM

@DaniAO I know we're still up in the air on the labeling at the tool head side but did we land on confirmation that this part of the fix is good to move forward with?

DaniAO added a comment.EditedJan 8 2019, 3:14 PM

This was a request from Marketing, but we haven't seen any of the parts to approve or not.

@west like we discussed please print out these and the new tube labels and we can get approval on this.