Page MenuHomeAleph Objects Inc

create insert diagrams
Closed, ResolvedPublic


We will need insert diagrams for all printed parts with inserts with the same formatting used here:

Event Timeline

logan created this task.Nov 27 2018, 11:43 AM
logan created this object with edit policy "LulzBot Hardware Products (Project)".
kent triaged this task as Low priority.Nov 27 2018, 11:44 AM

Yes, but in an effort to reduce the chances of re-doing work we should wait until later. Maybe pre-beta or mid-beta.

DaniAO assigned this task to west.Jan 21 2019, 10:49 AM
DaniAO added a subscriber: DaniAO.

This needs to be done for production before the build Betas.

Steven reassigned this task from west to kent.Jan 24 2019, 12:43 PM
kent added a comment.Jan 24 2019, 2:45 PM

we need inserts for the caution hot logo plate on the blower duct
the see through part on the usb mount is a little visually confusing
the y corner pp-is0090 has the insert going into the rod hole which is close, but not right
the y-motor I thought was going to be using nylocs, not sure if that's still the plan
pp-is0099 has a typo in the filename
pp-is0103 is a little confusing with the see though projection
pp-is0108 the bloom needs to be picked of on most of those and we should add a note
pp-is0107 we should make a note to use insulator to keep from getting iron burns on the part since that's probably going to be a frequently failed out part for that issue.
we need insert drawings for y chain pivot mount, lcd mount, y-idler, and the carriage cap where the name plate screws in
all these drawings use the copyright 2018 template, when we have a 2019 one i think.

west added a comment.Jan 24 2019, 2:51 PM

my freecad doesnt use the 2019 template if we have it. I'm waiting on you to merge T3841 to complete the blower shroud

west added a comment.Jan 24 2019, 2:53 PM

there is a ticket to update the 2018 to 2019 but nothing has been done

west added a comment.Jan 24 2019, 3:07 PM

On PP-IS0103 the clear projection allows the bloom removal callout. An insulator would make it difficult to insert the x idler, i recommend not using it. In all the x idlers that ive inserted, the wall around the z anchor has not been burned. Even if it were the z belt anchor would cover it. Y idler is Y idler housing the extruder cap is waiting on a pn to be made

west added a comment.Jan 24 2019, 3:08 PM

The y motor is using nylocs and as such does not exist as an inserted drawing

kent added a comment.Jan 24 2019, 3:09 PM

Are you sure? I have made some drawings with the 2019 template. I've been using the drawing dimensioning module and then pointing it to the template on the network drive. Not sure if these were done with techdraw or if that makes a difference.

@kent i modified the titleblock to 2019 in the shared-j titleblock location

kent closed this task as Resolved.Jan 25 2019, 11:29 AM

Ok these are merged in now with 6c261cb974cf