Add 2x 9.5mm ptfe chunks to BoM
Closed, ResolvedPublic

Description

We missed the 2x pieces of ptfe feed tube that get put into the input of the filament sensor

west created this task.Wed, Nov 28, 7:38 AM
west added a subscriber: Steven.Tue, Dec 4, 4:47 PM

@Steven should we get a drawing of all the lengths of feed tube to send out?

west added a comment.Tue, Dec 4, 4:48 PM

otherwise the 19mm total is added to the bom

Steven added a comment.Fri, Dec 7, 6:05 AM

@west yes a drawing would be good so we have a clear document to give to the supplier rather than relying on text in an email or part description.

west added a comment.Mon, Dec 10, 10:46 AM

@Steven is this something we would get cut out of house? For PN creation purposes

kent added subscribers: DaniAO, kent.Tue, Dec 11, 9:52 AM

The BOM.csv somehow became a binary on the branch. The drawing for the ptfe chunk is missing tolerances on the ID and OD. There are also some commits to the branch for the y-bearing holder that should be in T4807. Once we address these three things, this should be ready to merge @DaniAO

west added a comment.Tue, Dec 11, 9:53 AM

@kent can you remove the Y bearing holder changes? there doesnt need to be a ID and OD tolerance since this is an off the shelf part that is getting cut down to size

west added a comment.Tue, Dec 11, 10:06 AM

@kent should be good to go

kent closed this task as Resolved.Tue, Dec 11, 12:54 PM

The lack of a tolerance is still an issue, but I don't feel like arguing and it probably doesn't matter that much so I just merged it in.