OHAI Taz 5 dual extruder V3 installation guide.
Open, Needs TriagePublic

Description

https://ohai.lulzbot.com/project/LulzBot-TAZ-5-Dual-Extruder-v3-Install/ is a link to the guide and step 17 NOTE section goes over setting your z-offset through the LCD screen. The Taz 5 firmware doesn't have the Z-offset adjustment through the LCD screen and uses the button shown in step 18 instead.

I just wanted to bring it to your attention.

bigmansas created this task.Sat, Dec 1, 4:46 PM