Page MenuHomeAleph Objects Inc

Design X, Y and Z calibration print
Closed, DuplicatePublic


Something similar to this model.

Event Timeline

DaniAO created this task.Dec 4 2018, 1:45 PM
DaniAO created this object with edit policy "LulzBot Hardware Products (Project)".

That is wicked cool. May I suggest a cube of one color then, on the corresponding sides, have "X,Y,Z" in another color? may be less time than the thingiverse model. Just a quick thought. :)

west added a subscriber: west.Dec 18 2018, 4:17 PM

@tutley can you upload you calibration print?

Assign E1 to xyz_sub_mm_cal_pt1
Assign E2 to xyz_sub_mm_cal_pt2

logan added a subscriber: logan.Jan 4 2019, 11:06 AM

Here is a quicker vernier scale for X/Y, it also has two small squares and the quick circle split into 2 colors to calibrate z nozzle offset. I was able to measure the height of the two squares and apply the difference to the offset with good results. Whole print takes 25 minutes vs about 90 minutes.

Here is a quick cube print that I made that does well at visualizing offsets

kent added a subscriber: kent.Jan 21 2019, 1:25 PM

We have been seeing a few of these with small cylinders. I checked the dimensions in the model and they are 10mm with a polycount in the hundreds. Maybe this is something we can tune in with the horizontal expansion setting (or maybe some other cura setting).

kent added a subscriber: Steven.Jan 21 2019, 1:26 PM