Page MenuHomeAleph Objects Inc

Y build plate
Closed, ResolvedPublic


The hole for the calibration cube needs to be masked on both sides or plugged by the supplier. It gets very difficult to screw in the stainless steel screw during assembly. I have tested the calibration cube its self and does not cause any issues when screwing in the SS screw.

Event Timeline

kforrest created this task.Dec 6 2018, 7:38 AM
kforrest created this object with edit policy "LulzBot Hardware Products (Project)".
west added a comment.Dec 6 2018, 7:45 AM

I dont think masking the hole will help the issue, the drawing calls that hole out as 3.0mm +-0.75 so it is likely undersized. We can update the drawing to make it 3.0mm +0.5 and mask all holes that is mentioned in T4502

west moved this task from Report Issues Here to Needs Review on the Quiver board.Dec 6 2018, 12:13 PM

I believe that would help. I did not have any that were stuck. They're just very difficult to tighten. it was only the hole that was not beveled.

@west this branch has a commit that I think should not be there ac6f363e65fd2bb39ce0ccc53fa2fa860eff4a83 . Can I revert that or does it need to be pulled to another branch?

Steven closed this task as Resolved.Jan 9 2019, 3:40 PM

This is now merged into master.