Page MenuHomeAleph Objects Inc

Make frame feet round instead of square
Closed, ResolvedPublic

Description

The square feet have to be aligned, round feet would not need alignment.

Event Timeline

kent created this task.Dec 6 2018, 12:35 PM
kent triaged this task as Normal priority.
kent changed the edit policy from "All Users" to "LulzBot Hardware Products (Project)".
west lowered the priority of this task from Normal to Wishlist.Dec 10 2018, 7:21 AM
kent added a comment.Dec 10 2018, 10:35 AM

Other thing I've noticed in the same vein is that if you move the printer across a desk and bump one of the feet, it will come out of alignment even if it was in alignment to begin with.

@west @tutley any feed back on this one?

@DaniAO no complaints on my end

@EricNugent or @MikeR any issues with printing and install of these new feet?

@Steven it was a very simple install the round feet, only minor issue that may not be a big deal is they are small enough for a little bit of the metal from the extrusions is poking out the sides. Could be a poking hazard , other than that it was good in the neighborhood.

Steven closed this task as Resolved.EditedJan 10 2019, 12:11 PM

@MikeR thanks! This is now merged into master.