Page MenuHomeAleph Objects Inc

Extra move after pause on filament run out
Open, Needs TriagePublic

Description

When printing from USB flash drive, after a filament run-out, the head moves to the park location but then slowly returns to above the print.

This behavior has been verified in .66, but I have not yet been able to locate the cause.

Event Timeline

marcio created this task.Jan 4 2019, 11:23 AM
west added a subscriber: west.Jan 8 2019, 12:22 PM

is there a feed set when moving back to the print position? I could be using the same feedrate as the re-prime move

DaniAO added a subscriber: DaniAO.May 29 2019, 1:18 PM

@marcio last update was January 29th.. and we have had several updates to firmware. Is this still an issue?

I don't know.