Page MenuHomeAleph Objects Inc

Probing Issue - Missing top of washer
Closed, ResolvedPublic

Description

I have one of the betas with the vinyl graphics applied (no serial number). During the bed leveling sequence the nozzle is not contacting the top of the front right washer. Instead, the side of the nozzle is contacting the washer.

The nozzle does contact the rear right washer on the top but only by a hair.

Event Timeline

eBeardslee assigned this task to west.
adam added a subscriber: adam.Feb 18 2019, 9:27 AM
west added a comment.Feb 19 2019, 7:29 AM

@eBeardslee is the toolhead cable routing on the right side running behind the extruder motor or to the side of the motor?

west added a comment.Feb 19 2019, 8:25 AM

@eBeardslee can you send me a pic of your toolhead. I have a suspicion that it was built wrong

@west can you be more specific as to which part of the tool head you would like to see?

west added a comment.Feb 19 2019, 9:05 AM

the right motor

west added a comment.Feb 19 2019, 9:19 AM

@eBeardslee from the looks of it, the issue I saw on another beta isnt on yours. Move the cabling on the right extruder so it sits on the side of the motor. On yours its tucked behind the motor toward the top

Like you suggested, this leveling issue was due to the fact that the wiring had moved behind the motor

logan added a subscriber: logan.Feb 22 2019, 7:48 AM

I have seen this issue as well, and end up having to pull it forward every few prints.

EricNugent closed this task as Resolved.Mar 22 2019, 9:18 AM
EricNugent added a subscriber: EricNugent.

This issue should be resolved with the implementation of T5889