Page MenuHomeAleph Objects Inc

gcodes in software directory that are not software
Closed, WontfixPublic


There are some g-code in software which I don't think belong there.

I'm not exactly sure where a better place to put them is, maybe in sample prints? @karrad
do you have a preference for where the start/end gcodes and x level gcodes and stuff goes?

Event Timeline

kent created this task.Mar 5 2019, 2:22 PM
kent triaged this task as Normal priority.
kent created this object with edit policy "LulzBot Hardware Products (Project)".

@kent In the past we have stored them in the software section, as they are required for customers using different slicers. (S3D, Slic3r, etc)

I can't really think of a better place, but am open to suggestions.

@TyTh @Galadriel Do you all have a preference here?

TyTh added a comment.Mar 5 2019, 2:32 PM

I do not have a preference

kent closed this task as Wontfix.Mar 5 2019, 3:42 PM
kent added a subscriber: Steven.

Ok @karrad that makes sense to me, since you would need them to use an alternate slicer. Unless I hear otherwise, I'm not going to work on fixing this.