Page MenuHomeAleph Objects Inc

Change extruder current to 1.1 A
Closed, WontfixPublic

Description

I believe we could bump the extruder motors up to 1.1A for better torque.
This is just an idea, not a "we have to do this".

The motors are rated for 1.5A and I believe we can get the drivers to 1.4A (will have to check)

Event Timeline

west created this task.Mar 11 2019, 10:34 AM

The motor current on the extruder was higher at one point, but this was causing clicking on some toolheads. See T5137. If we increase the current again, we might run into similar issues.

DaniAO closed this task as Wontfix.Wed, May 22, 11:07 AM
DaniAO added a subscriber: DaniAO.

being that this may cause problems, going to close it as won't fix. We can look at it later down the road if needed.