Page MenuHomeAleph Objects Inc

Foye_First Article Report: PP-FP0149 Electronics chassis HD touchscreen
Open, Needs TriagePublic

Description

First article inspection notes from the manufacturer:

03-26-19

QC: Please include any notes on the initial first inspection.
Purchasing: Once QC has approved initial inspections, please alert supplier of current status.

Event Timeline

oliver created this task.Apr 4 2019, 9:22 AM
oliver moved this task from Restricted Project Column to Restricted Project Column on the Restricted Project board.Apr 4 2019, 9:29 AM
oliver renamed this task from First Article Report: PP-FP0149 Electronics chassis HD touchscreen to Foyer_First Article Report: PP-FP0149 Electronics chassis HD touchscreen.Apr 5 2019, 10:30 AM
oliver renamed this task from Foyer_First Article Report: PP-FP0149 Electronics chassis HD touchscreen to Foye_First Article Report: PP-FP0149 Electronics chassis HD touchscreen.
AOJAS added a subscriber: AOJAS.EditedApr 8 2019, 7:39 AM

QC Evaluation:
Dimension Specification: Pass
Cosmetics: Pass, Very good quality. some units had shipping damage, example show on Picture 1. Picture 2 is provided to show the general appearance of the unit.
Cosmetic Notes: The black silkscreen is appears to be thin, causing it to have a more textured appearance than our current products.

The powder coating on these units was of high quality, but measured thick in some areas.
Powder coat thickness average of 0.18mm measured on the top face of the unit.
Powder coat thickness average of 0.17mm mesasured on side face of unit.
Powder coat thickness average of 0.17mm mesasured on back face of unit.
This thickness goes above our tolerances((0.5mm to 0.12mm), but shouldn't pose an issue to the functioning of the machine as far as I know. I believe the only the parts that have a mechanical issue with thick powder coat are Mini frame parts currently, since we no longer do laser engraving.
MER and R&D should give feedback on this issue, if they think it will be an issue, as the drawing still has a powder coat thickness tolerance.
Powder coat thickness average of 0.12mm noted on front(in spec)

The overall appearance of the powder coating was high quality. If it isn't an in issue for the mechanical functioning of the part, then I would advise allowing them to continue doing it as they are.
@west, @kent, @tutley

@kim : We are good to proceed with the supplier on this part, but they will need feedback on the silkscreen thickness.

AOJAS added subscribers: west, tutley, kent.EditedApr 8 2019, 7:41 AM

Picture 1

Picture 2

tutley added a comment.Apr 8 2019, 8:11 AM

@AOJAS The slightly thicker powder coat on these chassis should be no problem!

oliver moved this task from Restricted Project Column to Restricted Project Column on the Restricted Project board.Apr 8 2019, 9:39 AM

First article has been measured and all artwork is in place. Screenprint looks to be of good quality as well with no smudging or misalignment. All art is approved.