Page MenuHomeAleph Objects Inc

EL-HR0151 CB X Harness pinned incorrectly
Closed, ResolvedPublic

Description

While building CB Assemblies this week we've found a majority of the stock for EL-HR0151 CB X Harness was pinned incorrectly (reversed) on the Archim side.
The drawing is correct.
We have been catching this at testing, however, at the moment they are leaving the cover off until after testing which lessens the amount of rework time needed.

This may not be of concern if outsourcing to a supplier with their own testing procedure. For prior machines we had in-house testing procedures and equipment in place to be used when/if we need to produce any of those harnesses in-house.

Event Timeline

logan created this task.Apr 24 2019, 2:20 PM
logan created this object with edit policy "LulzBot Hardware Products (Project)".

@guadalupe @draubach just something to be aware of for these harnesses.

DaniAO closed this task as Resolved.May 22 2019, 11:16 AM
DaniAO claimed this task.

I haven't heard this being reported any more, so closing this one down. If it does become a problem again, we can always reopen.