Page MenuHomeAleph Objects Inc

Frame QA - Z-Motor fasteners
Open, Needs TriagePublic

Description

We should consider adding the following to the frame QA sheet:

The Z-Motor mounting fasteners are not loose.

And clarify the following:

The set screws are torqued to spec.

To read as:

The Z-Motor pulley set screws are torqued to spec.

Event Timeline

logan created this task.Thu, Apr 25, 7:53 AM
logan created this object with edit policy "LulzBot Hardware Products (Project)".
kent added a comment.Thu, Apr 25, 7:56 AM

This needs to include the x-motor and x-motor pulley set screws too.

DaniAO added a subscriber: DaniAO.Thu, Apr 25, 7:58 AM

We already have 1000 plus of these printed.. so it will have to be on the next round.

If possible we should also add to "Check z motor screws to make sure they are not cross threaded and sitting flat against the 3d printed part." I don't know if this is still a problem, but it had been a problem last week and prior. Due to the angle of the hex driver needed to get the z motor screws screwed in, they have a tendency to cross thread and go in at an angle, if not careful.

DaniAO assigned this task to kent.Wed, May 15, 8:25 AM