Page MenuHomeAleph Objects Inc

Polycast is under all but not supported
Closed, InvalidPublic

Description

Cura LE Version: 3.6.8

Operating System: Whatever our internal computers run at

Printer: TAZ6

Tool Head: V3

Description of issue: Polycast by Polymaker shows up under the all section, but not under supported or experimental sections

Event Timeline

TyTh created this task.May 9 2019, 11:26 AM
karrad assigned this task to TyTh.May 9 2019, 12:38 PM
karrad triaged this task as Normal priority.
karrad added a subscriber: karrad.

@TyTh Polycast is currently under the intermediate section. As we have not done thorough testing with the other materials, we have not put it in supported as of yet.

Do you feel it is ready to be considered supported on the V3 dual extruder as is?

TyTh added a comment.May 9 2019, 1:28 PM

@karrad
I did not know it was under intermediate, I thought I remembered it was under supported. Can't speak to whether its ready or not

karrad closed this task as Invalid.May 9 2019, 1:30 PM

Sounds good, going to close this one down. If you are going to be doing a lot of it for contract mnfg, let us know how it goes. If you don't need to make tweaks we will swap it over to supported for the next release.