Page MenuHomeAleph Objects Inc

Marlin Mini 2
Closed, InvalidPublic


After updating a mini 2 with SE tool head, the Probe Z offset option in the GLCD is not functioning. After selecting it only states an offset of "0.00" and when trying to adjust the offset you cannot change the number by turning the wheel.

Event Timeline

karrad created this task.Jul 9 2019, 10:26 AM
karrad triaged this task as Normal priority.
karrad created this object with edit policy "Marlin (Project)".

Unable to reproduce this. Did you do a factory reset?

karrad closed this task as Invalid.Jul 10 2019, 10:58 AM

@marcio Flashing through Cura LE, I left the update EEPROM checked but did not manually restore failsafe.

Testing this morning, I am not seeing the same issue. I did not have to restore failsafe however. Going to close this one out and will re-open if I can reproduce. (Guessing I flashed wrong firmware, or disconnected before complete. PEBKAC)