Page MenuHomeAleph Objects Inc

Kangaroo Paw Toolhead Milled Parts for Alpha
Open, NormalPublic

Description

We have received parts for the Kangaroo Paw from PO32143. These parts range from PP-MP0277 through PP-MP0281. If these parts work for R&D we would like to use them for the alpha/beta build of the KP printer. These parts are being sent to Tyler in R&D for review. After that we need to send the parts to Kent who will create a FA check sheet to test to. If the parts all pass FA we can then use them for alpha/beta builds.

Event Timeline

jperry created this task.Tue, Jul 9, 11:58 AM
kent changed the edit policy from "All Users" to "Restricted Project (Project)".Tue, Jul 9, 12:05 PM
kent triaged this task as Normal priority.Tue, Jul 9, 12:13 PM
kent added a project: Restricted Project.
kent moved this task from Restricted Project Column to Restricted Project Column on the Restricted Project board.

i visually looked at the parts and they looked good, i did not check any measurements or anything. This would be done by @AOJAS
I have sent the parts with james to go back to @tomc

kent moved this task from Restricted Project Column to Restricted Project Column on the Restricted Project board.Wed, Jul 10, 1:23 PM
kent added a comment.Wed, Jul 10, 2:31 PM

A note on these parts: these were made to step files, not to drawings. Step files don't have any tolerances so these are not NCMR-able if they don't end up meeting the spec.

the step files match the drawings, so we should be good in theory

kent added a comment.Wed, Jul 10, 4:01 PM

the step files match the drawings

No they don't. One has tolerances and one doesn't.

@kent but the drawings were made from the step files. The step files are exactly the target dimensions, the drawings are only there to specify allowable tolerances on the target dimensions and other manufacturing notes like surface finish, material, etc. Its not like they re model every part based on the drawings. They use the provided step file to generate path for the mill, then use the drawings to ensure everything is within the tolerances specified. Also these were made by JMT who had a few questions about the drawings when they got the PO. So they were made with the drawings in mind

kent added a comment.Fri, Jul 12, 10:53 AM

I don't think we provided drawings at the time of the PO, but maybe I'm operating off incomplete information.

we definitely did. i got questions from JMT about them so i know they had them

kent moved this task from Restricted Project Column to Restricted Project Column on the Restricted Project board.Fri, Jul 12, 3:34 PM

Here are the inspection forms with the annotated drawings attached.

kent reassigned this task from kent to AOJAS.Thu, Jul 18, 8:04 AM

@AOJAS can you take the measurements for these parts?