Page MenuHomeAleph Objects Inc

Hardened Extruder Not Plunging Far Enough During Probing Sequence
Closed, ResolvedPublic

Description

While testing the start gcode for the Hardened Extruder on 3 different Taz 6 machines, 5/6 times I tested it, the nozzle wouldn't plunge down far enough to reach the washers and would not register touching the washer and a rewipe would start. During the rewiping sequence it still did not plunge far enough.

I think if we can add an extra 0.5mm to the plunge depth, then it will hit those washers without plunging too far to hurt the bed if the nozzle isn't clean.

Once this is done, I can re-test the firmware to see if it is far enough for all machines.