Page MenuHomeAleph Objects Inc

TAZ 6 PCTPE Profiles
Closed, ResolvedPublic

Description

Lets get a baseline for the PCTPE profiles that are currently imbedded in Cura 2

Event Timeline

karrad created this task.Jun 6 2017, 7:40 AM

I started the testing on the standard profile

lansky added a subscriber: lansky.EditedJun 9 2017, 1:55 PM

Doing this on SD card due to not being able to complete a print over USB. See T888.

If you don't vigorously clean the hotend after every print, you get a lot of Clean Nozzles error. On one printer, it failed 3 times in a row. I thinking maybe a higher wiping temp would be good.

Apologizes, that was me logged in as Matt

Completed Standard. The leveling really is bad, I cannot get a successful leveling without good cleaning, and picking off leaking filament with tweezers before the print.

I've tried lower leveling temperatures but no change. I'm going to confer with David on Monday to see what we might be able to do for High speed or High detail.

DaniAO added a subscriber: DaniAO.Jun 19 2017, 2:27 PM

Notes from the Proflie meeting on 6/15/17

Check the probing and wiping temps
Check all temps in general, they seem to be a bit too hot
Check the bottom speed, and possibly increase
check the retraction speeds

karrad reassigned this task from nickp to DaniAO.Jun 23 2017, 3:21 PM
karrad added a subscriber: nickp.
DaniAO reassigned this task from DaniAO to victor_larchenko.Jun 23 2017, 3:33 PM
DaniAO added a subscriber: victor_larchenko.

Updated the probing and wiping temps to 195. Changed the printing temp to 225. Retractions speeds were changed to 2 mm, and 20 mm per second. did not change the bottom speeds at all

@victor_larchenko Please incorporate these profiles into the Cura 2 protected files.

Thank you!

victor_larchenko closed this task as Resolved.Jun 25 2017, 11:18 PM