Page MenuHomeAleph Objects Inc

Alloy 910 TAZ 6
Closed, ResolvedPublic

Description

Lets get a baseline for the current 910 profiles imbedded in Cura 2

Event Timeline

karrad created this task.Jun 6 2017, 7:41 AM

Starting testing on 910 standard Taz6 now!

Settings look really good! Bearing test done looks great! Will continue and then make observations as needed.

nathan added a subscriber: nathan.Jun 7 2017, 5:48 AM

The splatbag on the Taz 6 failed twice in the same place, once on the SD and once through Cura2. Otherwise running well. Just starting the file on the Mini, so we will see if the issue carries over.

nathan added a comment.EditedJun 8 2017, 6:01 AM

I have been running into issue for the profiles with the WIP-More supports print (the little robot) and with the Splatbag on the Taz 6. They auto level just fine, but about 2-3 layers in, the print cycles out, but the heat bed and tool head remain up to temp. I tried multiple reflashes of the firmware, but the issue continued. Everything else printed fine (albeit a few nozzle clean errors).

If you don't vigorously clean the hotend after every print, you get a lot of Clean Nozzles error. On one printer, it failed 3 times in a row. I thinking maybe a higher wiping temp would be good.

High speed was completed, robot is missing as we were running out of filament.

Updated profiles with softening and wiping temp change

We will be testing the wipe temps shortly!

Tested 4 prints so far. every print leveled properly, no bed leveling fails! Profile wiping change seems to work well.

@david.hall that sounds great. We will review the prints this Thu, if everything looks good we will go ahead and incorporate

Here are the updated Taz profiles for 910:




karrad added subscribers: victor_larchenko, nickp.

@victor_larchenko the above profiles posted by @david.hall on 6/21/17 are ready for incorporation within Cura 2

victor_larchenko closed this task as Resolved.Jun 22 2017, 2:20 AM